MIL-DTL-14072F
TABLE IV. Finishes or processes other than painting or plating (E) continued.
1/ The primary purpose of this treatment is the removal of embedded iron, steel or other
foreign metallic particles.
2/ Anodic films are satisfactory for Type I surfaces only on small unthreaded parts.
3/ Type II is the preferred anodic treatment; however, it should not be used on surfaces
subject to stresses or surfaces containing lapped joints or crevices which could entrap
the sulphuric acid anodizaton solution. Type I anodization should be used in these
cases. Type III anodization is intended to provide greater wear characteristics,
abrasion resistance and improved corrosion protection.
4/ Colored chromates as they normally occur in processing operations are desired. The
use of clear or bleached chromate is prohibited.
45
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business