MIL-DTL-5541F
AMERICAN SOCIETY FOR QUALITY (ASQ)
ASQ-Z1.4
-
Procedures, Sampling and Tables for Inspection
by Attributes
(Copies of this document are available from American Society for Quality, 600 North
Plankinton Ave., Milwaukee, WI 53203 or https://www.asq.org.)
SOCIETY OF AUTOMOTIVE ENGINEERS (SAE) INTERNATIONAL
SAE-AMS4027
-
Aluminum Alloy, Sheet and Plate, 1.0Mg-0.60Si-0.28Cu-
0.20Cr, (6061; -T6 Sheet, -T651 Plate) Solution and
Precipitation Heat Treated. (DoD adopted)
SAE-AMS4037
-
Aluminum Alloy, Sheet and Plate, 4.4Cu-1.5Mg-0.60Mn,
(2024; -T3 Flat Sheet; -T351 Plate) Solution Heat Treated.
(DoD adopted)
(Copies of these documents are available from SAE International, 400 Commonwealth
Drive, Warrendale, PA 15096-0001 or https://www.sae.org.)
2.4 Order of precedence. In the event of a conflict between the text of this document and
the references cited herein, the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has
been obtained.
3. REQUIREMENTS
3.1 Materials. If no material type is specified type I shall be used. Unless otherwise
specified in the contract or order, substitutions of either type I for type II, or type II for type I
coatings are not permitted. The materials used to produce a chemical conversion coating shall be
approved for the selected type, class, form, and application method in accordance with the
qualification requirements of MIL-DTL-81706 and shall have been accepted for listing on the
applicable qualified products list (see 6.5). Replenishing chemicals, such as fluorides, added to a
bath to maintain its efficiency, shall not degrade the performance of the coating being applied.
3.2 Cleaning. Prior to coating, the base metal shall be mechanically or chemically cleaned
such that a water break-free surface is obtained after rinsing (see 6.6). Abrasives containing iron
such as steel wool, iron oxide, rouge, or steel wire are prohibited for all cleaning operations.
Treated parts that have become soiled shall be cleaned with materials that will remove the soil
without damaging the base metal, the part, or the conversion coating. If the coating is damaged,
the damaged area shall be recleaned and recoated or the part shall be rejected.
3.3 Application. Unless an application method is specified in the contract or order
3
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business