MIL-DTL-14072F
(Copies of these documents are available from www.sae.org or SAE World Headquarters,
400 Commonwealth Drive, Warrendale, PA 15096-0001.)
SOCIETY OF PROTECTIVE COATINGS
SSPC Paint 25
-
Zinc Oxide, Alkyd, Raw Linseed Oil, Primer,
and Primer, for Use Over Hand Cleaned Steel.
SSPC Paint 30
-
Weld-Through Inorganic Zinc Primer
(Copies of these documents are available from https://www.sspc.org or The Society for
Protective Coatings, 40 24th Street 6th Floor, Pittsburgh, PA 15222-4656. ).
2.4 Order of precedence. In the event of a conflict between the text of this
document and the references cited herein, the text of this document takes precedence.
Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
3. REQUIREMENTS
3.1 General. Selection of finishes shall be in accordance with the requirements
contained herein. Finishes selected shall conform to the specified thickness and shall not
interfere with the performance requirements of the equipment. Finishes, applied in
accordance with this specification, will inhibit the corrosion of metals and deterioration
of wood.
3.2 First article. The contractor shall furnish a sample unit(s) for first article
inspection of finishes as specified in the part or equipment document.
3.3 Materials. Finishing materials shall be in accordance with the requirements
specified herein. The contractor shall have in his possession, for examination by the
contracting officer or his duly authorized representative, satisfactory evidence that
materials used on the order comply with this specification.
3.4 Substitution for specified finishes, processes, or materials. If, due to special
conditions of service or design, the contractor considers that finishes, processes, or
materials other than those specified herein are necessary or more suitable, such finishes,
processes, or materials shall be used only upon receipt of prior approval from the
contracting officer. At the discretion of the contracting officer, samples may be required
to demonstrate the suitability of proposed substitutes.
3.4.1 "P" finishes on ferrous alloys. Table I permits finishes on ferrous alloys
(other than corrosion-resistant steels) when tank phosphating is not practical.
Phosphating in a tank may not be practical due to size, shape, or part fabrication method
such as welding. Prior to using these finishes, the contractor shall prove, to the
satisfaction of the contracting officer, that tank phosphating is not practical.
6
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business