MIL-STD-171 Finishing Of Metal And Wood SurfacesThis standard establishes and updates general finish codes and serves as a general guide to the selection of suitable materials, procedures, and system for cleaning, plating, painting and otherwise finishing of metal and wood surfaces.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65

MIL-STD-171F APPENDIX A.

Finish selection. (Continued)

Applicable finish recommendations

Conditions affecting

Type expo-

Cleaning and

Paint finishes

                       Class of part                                 finish selection             sure       pretreatment      Lusterless      Semigloss      Gloss        

10.  Wearing parts lubrication in service

a.  Parts will be oiled or greased but not during operation

II        5.3.1.3

b.  Parts will be splash or force-feed lubricated in operation

II        5.3.1.3

11.  Sliding wearing surfaces such as guide rails, etc., requiring electrical conductivity

Parts cannot be lubricated

II        1.4.1.3 or

1.4.1.3

Plus 1.2.2 (1.0 mil thick)

12.  Gears, cams, slides, etc.                    a.  Parts cannot be lubricated and will not be subjected to high temperature

II        1.1.2.2 or

5.3.1.3 plus 30.7

b.  Parts cannot be lubricated and will be subjected to high bearing pressure

II        1.4.1.3 or

1.4.1.3

Plus 1.2.2 (1.0 mil thick)

13.  Any type of part                                   An electrical conductive dissimilar metal contact is required

II        Any plate providing a permissible couple per table I

49

For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business