MIL-STD-1250 Corrosion Prevention And Deterioration Control In Electronic Components And Assemblies S/S By Mil-Hdbk-1250This standard establishes minimum requirements for procedures, materials and systems for protecting electronic components in DoD systems and assemblies from adverse environments. Protective measures shall be sufficient to maintain performance characteristics within specified limits both during and after exposure to moisture, high and low temperatures, corrosive gases, chemicals and microbial fungal attack.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47

MIL-STD-1250A

(Unless otherwise indicated, copies of the federal and military specifications, standards, and handbooks are available from the Standardization Documents Order Desk, Bldg. 4D, 700 Robbins Ave., Philadelphia, PA  19111-5094.)

2.2  Non-Government publication.  The following documents form a part of this document to the extent specified herein.  Unless otherwise specified, the issues of the documents which are DoD adopted are those listed in the issue of the DODISS cited in the solicitation.  Unless otherwise specified, the issues of documents not listed in the DODISS are the issues of the documents cited in the solicitation (see 6.2).

AMERICAN SOCIETY FOR TESTING AND MATERIALS  (ASTM)

ASTM G 15            -           Standard Terminology Relating to Corrosion and

Corrosion Testing

ASTM G 21            -           Standard Practice for Determining Resistance of

Synthetic Polymeric Materials to Fungi

ASTM B 117           -           Standard Test Method of Salt Spray (Fog) Testing

ASTM D 495          -           Standard Test Method for High-Voltage, Low- Current, Dry Arc Resistance of Solid Electrical Insulation

ASTM D 4300        -           Standard Test Methods for Ability of Adhesive

Films to Support or Resist the Growth of Fungi

(Application for copies should be addressed to the American Society for Testing and

Materials, 1916 Race Street, Philadelphia, PA  19103.)

SOCIETY OF AUTOMOTIVE ENGINEERS, INC.   (AEROSPACE MATERIAL SPECIFICATIONS)

SAE AMS 2401      -           Cadmium Plating, Low Hydrogen Content Deposit

SAE AMS 2404      -           Electroless Nickel Plating

SAE AMS 2416      -           Nickel-Cadmium Plating, Diffused

(Application for copies should be made to the Society of Automotive Engineers, Inc.,

400 Commonwealth Drive, Warrendale, PA  15096.)

(Non-Government standards and other publications are normally available from the organizations that prepare or distribute the documents.  These documents also may be available in or through libraries or other informational services.)

2.3  Order of precedence.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.  Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

6